How To: Configure an Epson L90 Label Printer

How To: Configure an Epson L90 Label Printer

Configuration Steps outlined below should be completed on initial configuration. Also to troubleshoot an issue with how the labels are cutting.
Sometimes this process must be ran through multiple times for it to correctly configure the labels.
Configuration Steps
  1. Turn printer Off
  2. Open roll paper cover (leave open)
  3. Turn printer back On
  4. Turn printer Off with cover open
  5. Then turn the printer On while pressing and holding Feed while the cover is still open.
  6. Hold the Feed button until the error and power light are on.
  7. Then once error light on press Feed button four times.
  8. Now close roll paper cover.
The printer should automatically feed labels to remember the label paper size.
If printer won't feed paper automatically when closing the cover the process was not successful and will need to be repeated starting on Step 1.

Epson TM L90 Label Printer- with peeler off
 

Epson TM L90 Label Printer- with peeler on

    • Related Articles

    • Epson TM-L90 Label Printer: User manual

      See the attached PDF User Manual. 
    • How to: Configure an Epson TM-U220 Impact Printer

      How to: Configure an Epson TM-U220 Impact Printer Overview In this article we will review how to change the network configuration of an Epson TM-U220 impact printer. It may seem a little daunting at first, but the whole process can usually be ...
    • How to: Factory Reset the Epson TM-U220 printer

      Reset the printer to factory defaults to wipe any existing configurations. Turn the printer OFF   Turn the printer upside down   Locate the Network Adapters on the rear underside of the printer. The small black dot below or above the yellow label is ...
    • How to Put a Star SP700 Printer into Epson Mode for use with QSR Automation

      Setting Up the Printer Turn off the power to the printer and unplug it. Flip it upside down. Unscrew the panel on the bottom. (This will require a Phillips head screwdriver.)  Note:  The dip switch panel is smaller than it might appear in these ...
    • Remotely setting static IP on Star Printer

      Remotely setting static IP on Star Printer All steps must be completed from a phone or iPad on the same network as the printer. Thermal Printer Printing current network configuration Turn off the printer at the switch Hold down the feed button, then ...